Xerox DocuPrint N24 Service Manual page 851

Network laser printer
Hide thumbs Also See for DocuPrint N24:
Table of Contents

Advertisement

Replacement
1 Reinstall the Eject Chute Assembly by first sliding the Stack Height Actuator and the Pinch Rolls
through the cutout in the Assembly.
2 Hook the two arms of the Eject Chute Assembly over the Pinch Roll Shaft.
3 Slide the front Pinch Roll Bearing to the rear so the arms of the Eject Chute Assembly ride on the
Bearing. Use one screw to secure the Bearing to the Finisher frame.
4 Slide the rear Pinch Roll Bearing to the front so the arms of the Eject Chute Assembly ride on the
Bearing. Use one screw to secure the Bearing to the Finisher frame.
5 Insert the Lever on the shaft and secure with the one screw.
6 Insert the Offset Lever into the Offset Cam and onto the Eject Pinch Roll Shaft. Use the E-ring to
secure the lever.
7 Raise and lower the Eject Chute Assembly to make sure it moves freely, and the Stack Height
Actuator and Pinch Rolls also move freely.
8 Reinstall the Eject Cover.
9 Reinstall the Upper Rear Cover.
10 Reinstall the Stapler Door Inner Cover Assembly.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-413
Options

Advertisement

Table of Contents
loading

Table of Contents