Rep 8.5.3.60 Set Clamp Motor And Drive Belt - Xerox DocuPrint N24 Service Manual

REP 8.5.3.60 Set Clamp Motor and Drive Belt

Parts List on PL 8.5.2.17
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Roll the Finisher away from the printer until it stops.
3 Remove the Upper Rear Cover (REP 8.5.3.5).
4 Remove the Eject Clamp Sensor (REP 8.5.3.57).
5 Remove the Offset Home Sensor (REP 8.5.3.58).
6 Remove the Eject Bracket Assembly (REP 8.5.3.59).
NOTE: It may be necessary to remove the Harness Cover (REP 8.5.3.8) and the Finisher PWB Cover
(REP 8.5.3.10) to access P864.
7 Disconnect P864(Figure 8.5.3.60a).
8 Disconnect J842 (Figure 8.5.3.60a).
9 Remove the two screws securing the Motor Bracket to the Finisher frame, and pull the Bracket
away from the Finisher frame (Figure 8.5.3.60a).
10 Free the Set Clamp Drive Belt from the Motor Pulley, and remove the Motor Bracket (Figure
8.5.3.60a).
11 Remove the E ring securing the Shaft Pulley to the Motor Shaft, and remove the Pulley (Figure
8.5.3.60a).
12 Remove the two screws securing the Set Clamp Motor to the Motor Bracket, and remove the
Motor (Figure 8.5.3.60a).
13 Remove the Set Clamp Motor Drive Belt from the Eject Pulley.
Options
Figure 8.5.3.60a. Set Clamp Motor.
3/99
8-408 DocuPrint N24, N32 and N40 Service Manual