Rep 8.2.3.13 Vertical Led / Sensor - Xerox DocuPrint N24 Service Manual

REP 8.2.3.13 Vertical LED / Sensor

Parts List on PL 8.2.2.6
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the ACT Cover Assembly (REP 8.2.3.5).
3 Remove the screw securing the LED Cover and LED to the Bin 1 Assembly, and remove the LED
Cover and LED (inset in illustration).
4 Disconnect P/J 823 located near the LED.
5 Remove the two screws securing the Lower Chute to the frame, and remove the Lower Chute.
6 Remove the screw securing the Vertical Sensor to the Lower Chute and remove the Sensor, wire
harness, and LED.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.2.3.13a. Vertical LED / Sensor.
3/99
8-101 Options