Xerox DocuPrint N24 Service Manual page 853

Replacement
1 Insert the rear of the Eject Pinch Roll Shaft Assembly into the bearing hole at the rear of the
Finisher.
2 Insert the front of the Eject Pinch Roll Shaft Assembly into the bearing hole at the front of the
Finisher.
3 Reconnect J832 to the Stack Height Sensor.
4 Slide the front and rear bearings over the ends of the Eject Pinch Roll Shaft.
5 Reinstall the Eject Chute Assembly.
6 Raise and lower the Eject Chute Assembly to make sure it moves freely, and the Stack Height
Actuator and Pinch Rolls also move freely.
7 Reinstall the Eject Cover.
8 Reinstall the Upper Rear Cover.
9 Reinstall the Stapler Door Inner Cover Assembly.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-415 Options