Xerox DocuPrint N24 Service Manual page 875

Replacement
1 Reinstall the Upper Transport Chute Assembly into the Finisher.
2 Use the two shoulder screws to secure the front and rear of the Upper Transport Chute to the
Finisher frame.
3 Reconnect J838 to the Compiler Bin Exit Sensor.
4 Route the wire harness through the clips that are located on the Upper Transport Chute
Assembly.
5 Position the support arm against the Top Cover Assembly, and use one screw to secure the
support arm.
6 Reinstall the Transport Motor Bracket.
7 Reinstall the Transport Motor.
8 Reinstall the Upper Rear Cover.
9 Reinstall the Stapler Door Inner Cover Assembly.
10 Reconnect the Finisher to the Printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-437 Options