Xerox DocuPrint N24 Service Manual page 763

Replacement
1 Place the Finisher PWB Cover up to the Finisher frame.
2 Install the wire harness in the retainer and secure the harness clamp.
3 Route the Finisher Interface cable through the cutout near the top of the Cover.
4 Route the AC Power cable through the Connector Cover opening of the Cover.
5 Reinstall the Finisher PWB Cover against the Finisher frame.
6 Use four screws to secure the Cover to the frame.
7 Reinstall the Harness Cover.
8 Reinstall the Connector Cover, route the AC Power cable through the cutout in the Connector
Cover. Slide the Cover onto the Finisher frame so the tab on the frame fits into the rectangular
cutout in the Cover.
9 Use one screw to secure the Cover to the frame.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-325 Options