Rep 4.10.12 Noise Filter Pwb - Xerox DocuPrint N24 Service Manual

REP 4.10.12 Noise Filter PWB

Parts List on PL 11.1
Removal
1 Switch off the printer power and disconnect the AC
Power Cord.
2 Remove the Upper Rear Cover Assembly (REP 4.1.3).
3 Disconnect the two wire plug (P19) from the top of the Noise Filter PWB (Figure 4.10.12a).
4 Disconnect the white wire from connector FS6 (Figure 4.10.12a).
5 Disconnect the black wire from connector FS5 (Figure 4.10.12a).
6 Remove the two screws that secure the Noise Filter PWB to the printer frame (Figure 4.10.12a).
7 Squeeze the tips of the two locking standoffs and remove the Noise Filter PWB (Figure
4.10.12a).
Replacement
1 Assemble in reverse order.
2 Verify proper operation.
Repair Procedures
Figure 4.10.12a. Noise Filter.
2/2000
4-100
CAUTION
These components are susceptible
to electrostatic discharge. Observe
all ESD procedures to avoid
damage.
DocuPrint N24, N32, N40, N3225 and N4025