Rap 8.5.7.13 Error Code "Fin Fail H5-81 Power Off/On - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.13 Error Code "Fin Fail H5-81 Power Off/On"

1 Remove the Eject Clamp Sensor from the Eject Bracket (REP 8.5.3.57). Enter Diagnostic Mode -
Input H/L - Finisher Clamp Sensor Detect - Eject. Insert and remove a piece of paper between
the Sensor arms. The Control Panel LCD displays L when the paper is inserted into the Sensor
and H when the paper is removed.
Y N
|
Replace the Eject Clamp Sensor (REP 8.5.3.57).
2 Reinstall the Eject Clamp Sensor (REP 8.5.3.57). Enter Diagnostic Mode - Input H/L - Finisher
Clamp Sensor Detect - Eject. Manually rotate the one-way gear that is attached to the Eject
Clamp Actuator and observe the action of the Actuator. The Control Panel LCD displays H when
the Actuator blocks the Sensor and L when the Actuator does not block the Sensor.
Y N
|
Replace the Eject Bracket Assembly (REP 8.5.3.59) or replace the Eject Clamp Actuator
(PL 8.5.2.19).
3 Enter Diagnostic Mode - Output - Finisher Operations - Eject CL / Off CW, to check the Eject
Clamp Motor. Observe the Eject Clamp Actuator as you run the test. The Eject Clamp Motor runs
and it rotates the Eject Clamp Sensor Actuator so it blocks the Eject Clamp Sensor.
Y N
|
Replace the Eject Clamp Offset Motor (REP 8.5.3.82).
4 Replace the Finisher PWB (REP 8.5.3.83). The error code reappears.
Y N
|
Problem solved.
5 Replace the Printer Engine Controller PWB (REP 4.10.6).
DocuPrint N24, N32 and N40 Service Manual
3/99
8-551 Options