Rep 8.5.3.65 Exit Shaft Assembly - Xerox DocuPrint N24 Service Manual

REP 8.5.3.65 Exit Shaft Assembly

Parts List on PL 8.5.2.12
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
3 Remove the Upper Rear Cover (REP 8.5.3.5).
4 Remove the Eject Cover (REP 8.5.3.7).
5 Remove the Eject Chute Assembly (REP 8.5.3.62).
6 Remove the Eject Pinch Roll Shaft Assembly (REP 8.5.3.63).
7 Remove the Upper Exit Chute Assembly (REP 8.5.3.64).
8 Remove the E ring securing the Paddle Shaft Drive Gear, that is located just below the Exit Shaft
Pulley, and remove the Drive Gear (Figure 8.5.3.65a).
9 Loosen the two screws that secure the Transport Motor Drive Belt Tension Assembly. Push the
idler pulley up to release the tension. Tighten the screws (Figure 8.5.3.65a).
10 Remove the screw securing the Exit Shaft Pulley to the Shaft, and remove the Pulley (Figure
8.5.3.65a).
11 Remove the E rings securing the front and rear Exit Shaft bearings, and remove the bearings
(Figure 8.5.3.65a).
12 Slide the Exit Shaft Assembly out of the Finisher frame (Figure 8.5.3.65a).
Replacement
1 Reinstall the Exit Shaft Assembly.
2 Reinstall the Exit Shaft Assembly front and rear bearings into the bearing cutouts at the front and
rear of the Finisher frame. Use an E-ring at both ends of the Shaft.
3 Reinstall the Exit Shaft Pulley onto the Exit Shaft, and use one screw to secure the Pulley to the
Shaft.
4 Ensure the Transport Motor Drive Belt is properly installed on all pulleys.
5 Loosen the screws that secures the Belt Tension Assembly.
6 Allow the assembly to properly tension the belt, then tighten the two screws.
7 Reinstall the Paddle Shaft Drive Gear and use the E-ring to secure the Gear to the Shaft.
8 Reinstall the Upper Exit Chute Assembly.
9 Reinstall the Eject Pinch Roll Assembly.
10 Reinstall the Eject Chute Assembly
11 Reinstall the Eject Cover.
12 Reinstall the Upper Rear Cover.
13 Reinstall the Stapler Door Inner Cover Assembly.
Options
3/99
8-418 DocuPrint N24, N32 and N40 Service Manual