Rap 8.5.7.27 Printer Does Not See The Finisher - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.27 Printer Does Not See The Finisher

1 Switch off printer main power. Disconnect and reconnect the two Finisher interface cables that
are connected to the printer. Switch on printer main power. The printer sees the Finisher.
Y N
|
Go to step 3.
2 Problem solved. Treat as an intermittent firmware problem, or possible connector/cable problem.
3 Replace the Finisher/Printer Harness Assembly (PL 8.5.2.21) and the AC In-Out Harness
Assembly (PL 8.5.2.20). The printer sees the Finisher.
Y N
|
Go to step 5.
4 Problem solved.
5 Replace the Printer Engine Controller PWB (REP 4.10.6). The printer sees the Finisher.
Y N
|
Replace the Finisher PWB (REP 8.5.3.83).
6 Problem solved.
Options
3/99
8-566 DocuPrint N24, N32 and N40 Service Manual