Rep 8.5.3.93 Transport Roll - Xerox DocuPrint N24 Service Manual

REP 8.5.3.93 Transport Roll

Parts List on PL 8.5.2.24
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Disconnect the Finisher from the Printer (REP 8.5.3.1).
3 Remove the Transport Assembly (REP 8.5.3.11).
4 Remove the IN Gate Solenoid Assembly (REP 8.5.3.90).
5 Remove the wire harness from the harness clips that are attached to the Bracket Assembly.
6 Unhook the Tension Spring from the Bracket Assembly.
7 Remove the two screws securing the Bracket Assembly to the Transport frame, and pull the
Bracket far enough away from the frame so you can access the Transport Gears.
8 Remove the E-ring securing the Transport Gear to the Transport frame, and slide the Gear off of
the shaft.
9 Open the Transport Cover.
10 Carefully lift up on the Transport Roll Guide while you release the three locking tabs securing the
Guide to the Transport, and remove the Guide.
11 Remove the two E-rings securing each end of the Transport Roll, and remove the Roll and
bearings.
Options
Figure 8.5.3.93a. Transport Roll.
3/99
8-460 DocuPrint N24, N32 and N40 Service Manual