Rep 8.5.3.78 Compiler Cover & Safety Interlock Switches - Xerox DocuPrint N24 Service Manual

REP 8.5.3.78 Compiler Cover & Safety Interlock Switches
Parts List on PL 8.5.2.16
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
3 Remove the Unload While Run Switch (REP 8.5.3.54).
4 Remove the two screws securing the Harness Holder to the Finisher frame, and push the Holder
out of the way (Figure 8.5.3.78a).
5 Disconnect J855 from the Compiler Cover Safety Switch (Figure 8.5.3.78a).
6 Remove the two screws securing the Safety Switch to the Finisher frame, and remove the Switch
(Figure 8.5.3.78a).
7 Disconnect J272A and J272B from the two Compiler Cover Interlock Switches (Figure
8.5.3.78a).
8 Remove the two screws securing the Switches to the Finisher frame, and remove the Switches
(Figure 8.5.3.78a).
Replacement
1 Reinstall the two Compiler Cover Interlock Switches to the Finisher frame, making sure the
Switch Actuators are under the Interlock Actuator. Use two screws to secure the switches.
2 Reconnect J272A to the Compiler Cover Interlock Switch that is against the frame.
3 Reconnect J272B to the other Compiler Cover Interlock Switch.
4 Reinstall the Compiler Cover Safety Switch to the Finisher frame, making sure the Switch
Actuator is under the leg of the Eject Chute Assembly.
5 Use two screws to secure the Safety Switch to the Finisher frame.
6 Reconnect J855 to the Safety Switch.
7 Reinstall the Harness Holder, and use two screws to secure it to the Finisher frame.
8 Reinstall the Unload While Run Switch.
9 Reinstall the Stapler Door Inner Cover Assembly.
Options
3/99
8-438 DocuPrint N24, N32 and N40 Service Manual