Rap 8.4.7.10 Error Code "Tray 5 Problem Service Required - Xerox DocuPrint N24 Service Manual

RAP 8.4.7.10 Error Code "Tray 5 Problem Service Required"

1 Slowly slide Tray 5 out of Feeder 5. The Tray 5 bottom plate drops as you slide the Tray out of
the Feeder.
Y N
|
Verify Tray 5 Lift Cables are free of damage. If OK replace Tray 5.
2 Enter Diagnostic Mode - Input H/L, Level Sensor Detect (Select Tray 5) to check the Tray 5
Paper Level Sensor. Remove Tray 5 from the HCF. Push up on the Nudger Roll so it clears the
Tray 5 Paper Level Sensor. The Control Panel LCD displays L before you push up on the Nudger
Roll and press [4] and H when lifted and press [4].
Y N
|
Check wiring between P/J119 and P/J484 (WIR 8.4.5.1). If OK, replace the Tray 5 Paper
Level Sensor (PL 8.4.2.4).
3 Remove Tray 3 from the HCF so you can observe Tray 5. Enter Diagnostic Mode Output Test, Lift
Up Motor Operation (Select Tray 5) to check the Tray 5 Lift Up Motor. The Tray 5 Lift Up Motor
runs and the Tray 5 bottom plate raises when the test starts.
Y N
|
Check wiring between P/J485 and P/J 216 (WIR 8.4.5.1). If OK, replace in order: Tray 5 Lift
Up Motor (REP 8.4.3.6), HCF PWB (REP 8.4.3.5), Printer Engine Controller PWB (REP
4.10.6).
4 Replace the HCF PWB (REP 8.4.3.5). The error message reappears.
Y N
|
Problem solved.
5 Replace the Printer Engine Controller PWB (REP 4.10.6).
Options
2/2000
8-258 DocuPrint N24, N32, N40, N3225, and N4025