Repair Procedures; Rep 8.1.3.1 Duplex Module Assembly - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

8.1.3 Repair Procedures

Parts List on PL 8.1.2.1

1 Switch off the printer power and disconnect the AC Power Cord.

2 Disconnect the Duplex Module interface cable from the rear of the printer.

3 Remove the screw securing the Front MBF Support Cover and remove the Cover.

4 Open the Duplex Module.

5 Unhook the Support Cable from the printer frame.

6 Support the Duplex Module with your left hand.

7 Close the Unit just enough so you can release the metal arm that runs from the Unit to the metal

stud on the Front MBF Support.

8 Open the Duplex Module all the way and lift it up to remove it from the printer.

1 Hold the Duplex Module so the front of the Unit is facing down and the metal hinges facing the

2 Slip both the front and rear hinges onto the metal studs on the Front and Rear MBF Supports.

3 Support the Duplex Module with your left hand.

4 Close the Unit just enough so you can hook the metal arm that runs from the Unit to the metal

stud on the Front MBF Support.

5 Hook the Support Cable to the printer frame.

6 Close the Duplex Module.

7 Reconnect the Duplex Module interface cable to the rear of the printer.

DocuPrint N24, N32 and N40 Service Manual

Figure 8.1.3.1a. Duplex Module Assembly

Table of Contents