Xerox DocuPrint N24 Service Manual page 867

9 Rotate the Drive Pulley to make sure the Belt tracks correctly and the Slider Bracket moves
smoothly along the Rail.
10 Reinstall the Stapler Rail into the Finisher frame. Use four screws to secure the Rail to the frame.
11 Reconnect P833 to the front Sensor, P834 to the middle Sensor, and P835 to the rear Sensor.
12 Route the wire harness through the harness clips that are located on the Stapler Rail.
13 Rotate the Stapler Transport Motor Drive Belt as you slip the Belt onto the Drive Pulley.
14 Reinstall the Stapler Assembly.
15 Reinstall the Upper Left Cover.
16 Reinstall the Transport Assembly.
17 Reinstall the Upper Rear Cover.
18 Reinstall the Stapler Door Inner Cover Assembly.
19 Reconnect the Finisher to the Printer.
Figure 8.5.3.71a. Stapler Rail Belt.
3/99
DocuPrint N24, N32 and N40 Service Manual 8-429 Options