Rap 8.5.7.24 Error Code "Stapler Fail H5-96 Power Off/On - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.24 Error Code "Stapler Fail H5-96 Power Off/On"

1 Remove the Upper Rear Cover (REP 8.5.3.5). Enter Diagnostic Mode - Input H/L - Finisher
Clamp Sensor Detect - Set Clamp Home, to test the Set Clamp Home Sensor. Rotate Eject Shaft
#1 so the Set Clamp Actuator located at the rear end of the Shaft actuates and deactuates the
Set Clamp Home Sensor. The Control Panel LCD displays L when the Actuator is between the
Sensor arms and H when the Actuator is clear of the Sensor.
Y N
|
Replace the Set Clamp Home Sensor (REP 8.5.3.79).
2 Enter Diagnostic Mode - Output - Finisher Operations - Set Clamp, to test the Set Clamp Motor.
The Set Clamp Motor runs.
Y N
|
Replace the Set Clamp Motor (REP 8.5.3.60).
3 Run Output - Finisher Operations - Set Clamp once, to position the Set Clamp Actuator. Exit the
Output test and enter Input H/L - Finisher Clamp Sensor Detect - Set Clamp Home. The Control
Panel LCD displays L.
Y N
|
Replace the Eject Shaft Assemblies (REP 8.5.3.61).
4 Replace the Finisher PWB (REP 8.5.3.83). The error code reappears.
Y N
|
Problem solved.
5 Replace the Printer Engine Controller PWB (REP 4.10.6).
Options
3/99
8-562 DocuPrint N24, N32 and N40 Service Manual