Rep 8.5.3.46 Top Bin Drive Belts - Xerox DocuPrint N24 Service Manual

REP 8.5.3.46 Top Bin Drive Belts

Parts List on PL 8.5.2.10
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Harness Cover (REP 8.5.3.8).
3 Remove the Top Bin Assembly (REP 8.5.3.38).
4 Remove the Top Bin Rear Cover (REP 8.5.3.39).
5 Remove the Top Bin Motor (REP 8.5.3.45)
6 Remove the Top Bin Front Cover (REP 8.5.3.43).
7 Remove the screw securing the Sensor Bracket to the Bin Frame, and remove the Bracket
(Figure 8.5.3.46a).
8 Unhook the Front and Rear Tension Springs from the Tension Plates (Figure 8.5.3.46a).
9 Loosen the screws (two each) securing the Front and Rear Tension Plates to the Bin Frame
(Figure 8.5.3.46a).
10 Remove the two screws securing the Limit Actuator to the Bin Frame, and remove the Actuator
(Figure 8.5.3.46a).
11 Remove the E ring secure the Drive Gear to the shaft, and remove the Drive Gear (Figure
8.5.3.46a).
12 Remove the screws (two each) securing the Front and Rear Belt Clamps to the Bin, and remove
the Clamps (Figure 8.5.3.46a).
13 Remove the Front and Rear Belts (Figure 8.5.3.46a).
Replacement
1 Reinstall the Front and Rear Drive Belts and secure with the Belt Clamps and screws.
2 Reinstall the Tension Springs on the Tension Plates.
3 Ensure the Top Bin is level within the Top Bin Assembly. If necessary, skip the belt teeth over the
pulley until the bin is level.
4 Tighten the Tension Plate screws.
5 Reinstall the Drive Gear on the shaft, and use an E-ring to secure the Gear.
6 Reinstall the Limit Actuator on the frame, and use two screws to secure the Actuator.
7 Reinstall the Sensor Bracket on the Bin Frame, ensure the Limit Actuator tab is aligned properly
in the Sensor Bracket. Use screw to secure the Bracket.
8 Reinstall the Top Bin Motor and Bracket.
9 Reinstall the Top Bin Front Cover.
10 Reinstall the Top Bin Rear Cover.
11 Reinstall the Top Bin Assembly.
12 Reinstall the Harness Cover.
Options
3/99
8-382 DocuPrint N24, N32 and N40 Service Manual