Xerox DocuPrint N24 Service Manual page 138

In the following steps, some of the components will be removed from the OLD assembly.
24 Remove the screw that secures the Tray Stopper to the assembly (Figure 4.2.6g). Remove the
stopper.
25 Release the locking tabs and remove the spacer from the assembly (Figure 4.2.6g).
26 Disconnect the harness from the Take Away Sensor (Figure 4.2.6h).
27 Press the locking tabs and remove the sensor from the assembly (Figure 4.2.6h).
28 Remove the screw that secures the flexible cable clamp to the rear of the assembly.
29 Note the orientation of the two bearings that are held in place by the Spring Support Assembly
(Figure 4.2.6i).
30 Remove the screw that secures the Spring Support Assembly and bracket (Figure 4.2.6i).
Remove the Spring Support Assembly.
31 Remove the outboard bearing, the E-ring, then the inboard bearing (Figure 4.2.6i).
Repair Procedures
Figure 4.2.6g. Retard Frame Assembly.
Figure 4.2.6h. Take Away Sensor.
2/2000
4-24 DocuPrint N24, N32, N40, N3225 and N4025