Rep 8.4.3.20 Tray 5 Removal - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

REP 8.4.3.20 Tray 5 Removal

Parts List on PL 8.4.2.13

NOTE: The removal of Tray 5 is technique sensitive.

1 Remove Tray 3.

2 Pull Tray 5 out to the Stopper position.

3 Reach down through the Tray 3 opening to the rear of Tray 5. Push the release tabs located on

the two rails and pull the Tray out approximately 1 inch (25mm) (Figure 8.4.3.20a).

4 Push the Left Rail extension to the left (Figure 8.4.3.20a).

5 Press until the rail stop clears the brass stopper (Figure 8.4.3.20a). Remove the Tray Assembly.

1 Align the Tray with the three guide rails and slide the Tray into the HCF.

DocuPrint N24, N32 and N40 Service Manual

Figure 8.4.3.20a. Tray 5.

Table of Contents