Rep 4.2.7 Tray 2 Take Away Roll And Retard Assembly - Xerox DocuPrint N24 Service Manual

REP 4.2.7 Tray 2 Take Away Roll and Retard Assembly

Parts List on PL 3.6
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Duplex Unit, if one is installed.
3 Remove the MBF Assembly (REP 4.3.1).
4 Remove the Lower Rear Cover (REP 4.1.4).
5 Remove Tray 2.
6 Open the Lower Left Cover.
7 Release the two locking tabs on the Lower Left Cover Interlock Sensor and remove the sensor
(Figure 4.2.7a). Allow the switch to hang down.
8 Pry up both ends of the plastic Feed Out Chute covering the Take Away Roll. Allow the chute to
rotate down and remove the Chute (Figure 4.2.7a).
9 Remove the screw that secures the metal Feed In Chute Assembly (Figure 4.2.7a).
10 Grasp the Chute Assembly from the paper tray side. Slide the chute toward the front of the
printer, then remove.
11 Remove the Retard Assembly Spring (Figure 4.2.7a).
12 Remove the E-ring from between the center white bearing and the rubber roll (Figure 4.2.7a).
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.2.7a. Take Away Roll.
2/2000
4-31 Repair Procedures