Xerox DocuPrint N24 Quick Installation
2,000 sheet finisher
Hide thumbs
Also See for DocuPrint N24:
- Service manual (1032 pages) ,
- System administrator manual (398 pages) ,
- User manual (100 pages)
Related Manuals for Xerox DocuPrint N24
Summary of Contents for Xerox DocuPrint N24
- Page 1 The Xerox DocuPrint N24, N32, and N40 2,000 Sheet Finisher Quick Installation/ Removal Guide...
-
Page 2: Before You Begin
CAUTION: Be careful of metal plate edges when installing the finisher. To operate this finishing device, your DocuPrint N24, N32, or N40 must be at software release 1.2 or higher. To verify your release, print a software configuration sheet from the printer. -
Page 3: Preparation And Unpacking
Remove any tape and packing material. Save the carton and packing materials for later use in case you ever need to ship the finisher back to Xerox. Unpack the installation kit. You should have these three items: (1) Transport Cover and thumb screw... - Page 4 X e r o x D o c u P r i n t N 2 4 , N 3 2 , a n d N 4 0 F i n i s h e r Face the front of the printer and place the Transport Cover on the top left side of the printer.
- Page 5 Install the Emissions Bracket Assembly Install the Guide Rail At the left side of the printer, align the #1 bracket with the third hole from the front, lift it over the printer’s plastic cover panel and hook its tab in the hole.
- Page 6 Hold the Paper Transport parallel to the ground and unfold the two brackets under the Paper Transport edge nearest to the printer by pulling on the green tabs. Rotate them into place by turning them down and to the side as shown and push them snugly against the retainers.
- Page 7 Open the access door on the side of the finisher. Align the finisher with the printer so they can be connected together. Align the pins on the left hand edge of the Paper Transport with the holes on the top edge of the Transport Cover.
-
Page 8: Complete The Installation
Configuration Sheet. If the finisher still does not appear on the sheet, contact the dealer from which you bought your printer and/or finisher, or contact Xerox. Install the printer drivers from the CD. The CD also contains the Finisher User Guide and the Finisher Install/Removal instructions. -
Page 9: Removing The Finisher
Removing the Finisher This section includes instructions for removing the finisher from the printer. Power OFF the printer. Be sure to save all the loose parts from the finisher and the printer. Remove the thumb screw from the base of the finisher. - Page 10 X e r o x D o c u P r i n t N 2 4 , N 3 2 , a n d N 4 0 F i n i s h e r Free the Guide Rail from the base of the printer console by pushing in the two tabs on the #2 bracket while pushing down on the Guide Rail.