Xerox DocuPrint N24 Service Manual page 122

Replacement
CAUTION Do not reinstall the Top Cover with the AC Power Cord connected to the printer. Top
Cover reinstallation may accidently switch on the Main Power Switch.
1 Switch off the printer power and disconnect the AC Power Cord.
2 Reconnect the wire harness to the Control Panel.
3 Reconnect the Fuser Fan inline connector.
NOTE: In the next step, be sure to insert the left end of the cover under the Stack Full Sensor
Actuator and the Exit Chute Pinch Rolls(Figure 4.1.2b).
4 Reinstall the Top Cover Assembly onto the printer frame.
5 Use two screws to secure the Top Cover Assembly to the Right Cover.
6 Reinstall the Fuser Full Cover.
7 Verify proper operation.
Figure 4.1.2b. Reinstalling Top Cover Assembly.
3/99
Repair Procedures 4-8 DocuPrint N24, N32 and N40 Service Manual