Xerox DocuPrint N24 Service Manual page 771

Replacement
1 Insert the inside Actuator pivot into the hole in the Docking Support and press the outside pivot
into the arms of the Actuator support.
2 Reconnect J855M to the Interlock Sensor.
3 Push the Actuator out of the way while you reinstall the Sensor.
4 Position the Sensor as shown in the figure, and press the latches on the rear of the Sensor into
the four holes in the Docking Support.
5 Rock the Actuator back and forth to make sure it moves freely between the arms of the Sensor.
6 Reinstall the Lower Left Cover.
7 Reconnect the Finisher to the printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-333 Options