RAP 7.50.1 0101 - SIMM1/DIMM1
1 Switch the printer power off. Remove System Controller PWB from System Controller Chassis.
Remove the SIMM/DIMM installed in Slot 1. Reinstall the System Controller PWB into its chassis
and switch the printer power on. The error message reappears.
Y
N
|
Go to Step 3.
2 Replace the System Controller PWB (REP 4.10.7).
3 Switch the printer power off. Remove System Controller PWB from System Controller Chassis.
Install the SIMM/DIMM removed in step 1 into Slot 2. Reinstall the System Controller PWB into
its chassis and switch the printer power on. The error message reappears.
Y
N
|
Go to Step 5.
4 Replace the SIMM/DIMM (PL 11.3).
5 Switch the printer power off. Remove System Controller PWB from System Controller Chassis.
Reinstall the SIMM/DIMM removed in step 1 into Slot 1. Reinstall the System Controller PWB into
its chassis and switch the printer power on. The error message reappears.
Y
N
|
Attribute problem to a poor connection of the SIMM/DIMM on the System Controller PWB
and go to 1.4 Final Actions.
6 Replace the System Controller PWB (REP 4.10.7).
DocuPrint N24, N32, N40, N3225, and N4025
2/2000
7-75
Repair Analysis Procedures (RAP)