Rep 4.8.3 Face Up Exit Sensor - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

REP 4.8.3 Face Up Exit Sensor

Parts List on PL 9.3

1 Switch off the printer power and disconnect the AC Power Cord.

2 Open the Duplex Unit if one is installed.

3 Remove the Fuser Full Cover (REP 4.1.1).

4 Disconnect the Face Up Exit Sensor in-line connector (P/J 109) (Figure 4.8.3a).

5 Release the locking tabs on each end of the Face Up Exit Sensor (Figure 4.8.3a). Remove the

1 Assemble in reverse order.

2 Verify proper operation.

Repair Procedures

Figure 4.8.3a. Face Up Exit Sensor.

DocuPrint N24, N32, N40, N3225 and N4025

Table of Contents