Xerox DocuPrint N24 Service Manual page 361

8 Insert all trays. Print a Configuration Sheet (5.5.2.2.1) for Version 1.7X and below or (5.6.2.2.1)
for Version 1.8X. The amount of memory listed on the Config Sheet matches the actual memory
in the printer.
Y N
|
Go to RAP 7.49.
9 Ask the customer to print a document from an application program at the host. The document
prints successfully.
Y N
|
Have the customer validate the application and printer setup.
10 The basic printer appears to be functioning properly. The printer has options.
Y N
|
Entry Level is complete.
11 Perform the following tasks in order as related to the option installed:
• Generate 20 System Controller Test Prints (5.5.2.2.2) for Version 1.7X and below or
(5.6.2.2.2) for Version 1.8X from Trays 3, 4, & 5, if HCF Option is installed.
• Generate 10 System Controller Duplexed Test Prints (5.5.2.2.2) for Version 1.7X and
below or (5.6.2.2.2) for Version 1.8X (Long Edge) from any input tray to all output bins,
if Duplex Option is installed.
• Generate 5 System Controller Test Prints (5.5.2.2.2) for Version 1.7X and below or
(5.6.2.2.2) for Version 1.8X from any input tray and output to each Mailbox Bin, if the
Mailbox Option is installed.
• Generate 20 System Controller Test Prints (5.5.2.2.2) for Version 1.7X and below or
(5.6.2.2.2) for Version 1.8X from Trays 3, 4, & 5, and output to each output bin with Dual
Stapled enabled, if the Finisher Option is installed.
All options tested above function properly.
Y N
|
Refer to the appropriate option check out procedure in Section (8).
12 Go to 1.4 Final Actions.
DocuPrint N24, N32 and N40 Service Manual
3/99
7-7 Repair Analysis Procedures (RAP)