Rap 7.3 Clear Area A / Reset Tray 1 (C1-3) - Xerox DocuPrint N24 Service Manual

RAP 7.3 Clear Area A / Reset Tray 1 (C1-3)

1 Inspect the paper that is loaded in the paper tray. The paper loaded in the tray is smooth (not
wrinkled) and undamaged.
Y N
|
Replace the paper with new paper.
2 Inspect the paper path for paper scraps or foreign objects that could cause a paper jam. The
paper path is clear.
Y N
|
Clear the paper path.
3 Enter Diagnostic Mode - 5.4.5 Running a Service Output Test, Feed Clutch Operation (Select
Tray 1) to check the Tray 1 Feed Clutch function. The Tray 1 Feed Clutch energizes when Output
Test starts.
Y N
|
Replace the Tray 1 Feed Clutch (REP 4.2.3).
4 Enter Diagnostic Mode and generate a Test Print (5.5.2.2.2) for Version 1.7X and below or
(5.6.2.2.2) for Version 1.8X. After generating a print, open the left upper cover and verify a sheet
of paper was fed into the registration area.
Y N
|
Replace the Tray 1 Feed Rolls (REP 4.2.5).
5 Enter Diagnostic Mode - 5.4.6 Running a Service Sensor (H/L) Input Test, Regi Sensor Detect.
Insert a sheet of paper into the Registration Sensor and press [4], then remove the sheet of
paper and press [4]. The Control Panel LCD displays H when paper is inserted into the
Registration Sensor, and displays L when the paper is removed.
Y N
|
Replace the Registration Sensor (REP 4.4.2).
6 Replace the Printer Engine Controller PWB (REP 4.10.6).
DocuPrint N24, N32 and N40 Service Manual
3/99
7-9 Repair Analysis Procedures (RAP)