Rap 7.1 Entry Level - Xerox DocuPrint N24 Service Manual

RAP 7.1 Entry Level

If the display indicates a Error Message/Error Code, or there is an obvious failure or fault, go
immediately to the appropriate Error Message/Error Code, Repair Procedure, or Repair Analysis
Procedure. If you are not sure where to begin, continue troubleshooting using the following steps. If the
printer exhibits intermittent operation and/or inconsistent failure symptoms, the problem may be due to
electrical noise.
1 Perform the following:
— Disconnect the AC power.
— Disconnect the Duplex Module, if installed.
— Disconnect the High Capacity Feeder, if installed.
— Disconnect the Mailbox Assembly, if installed.
— Disconnect the Finisher, if installed.
— Check the printer paper path for jammed paper or other obstacles
— Ensure that the paper trays have a good supply of fresh paper and are fully inserted in the
printer.
— Ensure the EP Cartridge is properly installed.
— Ensure that all covers are properly closed.
2 Reconnect the AC power cord and switch the AC power on. The Fuser Fan runs after two
seconds.
Y N
|
Go to RAP 7.27.
3 The fuser fan cycles three times during initialization.
Y N
|
Go to RAP 7.23.
4 Pull all paper trays except tray 1. Run a Test Print (5.5.2.2.2) for Version 1.7X and below or
(5.6.2.2.2) for Version 1.8X. Paper is delivered to the output tray.
Y N
|
Go to RAP 7.2.
5 The test print meets/surpasses the Image Quality Specifications established in RAP 7.43.
Y N
|
Go to RAP 7.33.
6 Pull tray 1 and insert tray 2. Run a Test Print (5.5.2.2.2) for Version 1.7X and below or (5.6.2.2.2)
for Version 1.8X. Paper is delivered to the output tray.
Y N
|
Go to RAP 7.4.
7 Pull tray 2. Run a Test Print (5.5.2.2.2) for Version 1.7X and below or (5.6.2.2.2) for Version 1.8X.
from the MBF. Paper is delivered to the output tray.
|
Go to RAP 7.7.
Repair Analysis Procedures (RAP)
3/99
7-6 DocuPrint N24, N32 and N40 Service Manual