Rap 8.4.7.3 Error Code "Paper Jam Clear Area C - Xerox DocuPrint N24 Service Manual

RAP 8.4.7.3 Error Code "Paper Jam Clear Area C"

1 Inspect the paper that is loaded in the paper tray. The paper loaded in the tray is smooth (not
wrinkled) and not damaged.
Y N
|
Replace the paper with new paper.
2 Inspect the paper path for paper scraps or foreign objects that could cause a paper jam. The
paper path is clear.
Y N
|
Clear the paper path.
3 Enter Diagnostic Mode - Output Test, Tray 4 Lift Motor to test the Tray 4 Lift Up Motor function.
The Motor switches on when the Output Test starts.
Y N
|
Check the wiring between P/J 212 and P/J 406 (WIR 8.4.5.1). If OK, replace Tray 3 Lift Up
Motor (REP 8.4.3.6).
4 Enter Diagnostic Mode - Output Test, Feed Clutch operation (Select Tray 4 to energize clutch
and TTM Feed Motor Operation to start HCF Motor to check the Tray 4 Feed Clutch function. The
Tray 4 Feed Clutch energizes and the Feed Rolls rotated when the Output Test starts.
Y N
|
Check the wiring between P/J 211 and P/J 406 (WIR 8.4.5.1). If OK, replace the Tray 3
Feed Clutch (REP 8.4.3.9).
5 After performing step 4, open the Left Upper Cover of the HCF. A sheet of paper was fed out of
the tray.
Y N
|
Replace Tray 4 Feeder Assembly.
6 Enter Diagnostic Mode - Input H/L, T/A Roll Sensor Detect (Select Roll 3). Insert a sheet of paper
into the Tray 3 Take Away Sensor and press [4], then remove the sheet of paper and press [4].
The Control Panel LCD displays "IS WITH PAPER" when paper is inserted into the Tray 3 Take
Away Sensor and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 121 AND P/J 406 (WIR 8.4.5.1). If OK, replace the Tray 3
Take Away Sensor (PL 8.4.2.11).
7 Replace the HCF PWB (REP 8.4.3.5). The error message reappears.
Y N
|
Problem solved.
8 Replace the Printer Engine Controller PWB (REP 4.10.6).
DocuPrint N24, N32 and N40 Service Manual
3/99
8-251 Options