Rep 4.10 Electronics; Rep 4.10.1 Main Switch - Xerox DocuPrint N24 Service Manual

REP 4.10 Electronics

REP 4.10.1 Main Switch

Parts List on PL 11.1
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Top Cover Assembly (REP 4.1.2).
3 Remove the screw securing the Main Switch Bracket to the Power Supply Assembly (Figure
4.10.1a).
4 Pull the Bracket and Switch up and out of the Power Supply.
5 Disconnect the four wires from the Switch.
6 Squeeze the two clips on the underside of the Switch while you slide the Switch out the top of the
Bracket.
Replacement
1 Slide the Main Switch into the opening in the top of the Main Switch Bracket until it snaps into
place.
2 Reconnect the four wires to the Switch. Connect the black wires to FS1 and FS2 and the white
wires to FS3 and FS4 (Figure 4.10.1a). The illustration represents the underside of the Main
Switch Bracket and Main Switch.
3 Reinstall the Main Switch Bracket onto the Power Supply Assembly.
4 Make sure you align the screw hole in the Bracket with the screw hole in the Power Supply.
5 Use one screw to secure the Bracket to the Power Supply Assembly.
6 Reinstall the Top Cover Assembly.
7 Verify proper operation.
Repair Procedures
Figure 4.10.1a. Main Switch.
2/2000
4-82 DocuPrint N24, N32, N40, N3225 and N4025