Rap 8.4.7.6 Error Code "Paper Jam/Clear Areas B,C - Xerox DocuPrint N24 Service Manual

RAP 8.4.7.6 Error Code "Paper Jam/Clear Areas B,C"

1 Inspect the paper that is loaded in the paper cassette. The paper loaded in the cassette is
smooth (not wrinkled) and not damaged.
Y N
|
Replace the paper with new paper.
2 Inspect the paper path for paper scraps or foreign objects that could cause a paper jam. The
paper path is clear.
Y N
|
Clear the paper path.
3 Enter Diagnostic Mode - Input H/L, T/A Roll Sensor Detect (Select Roll 2). Insert a sheet of paper
into the Tray 2 Take Away Sensor and press [4], then remove the sheet of paper and press [4].
The Control Panel LCD displays "IS WITH PAPER" when paper is inserted into the Tray 2 Take
Away Sensor and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 408 and P/J 143 (6.3.12). If OK, replace the Tray 2 Take
Away Sensor (PL 5.2).
4 Enter Diagnostic Mode - Input H/L, T/A Roll Sensor Detect (Select Roll 3). Insert a sheet of paper
into the Tray 3 Take Away Sensor and press [4], then remove the sheet of paper and press [4].
The Control Panel LCD displays "IS WITH PAPER" when paper is inserted into the Tray 3 Take
Away Sensor and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 121 and P/J 406 (WIR 8.4.5.1). If OK, Replace the Tray 3
Take Away Sensor (PL 8.4.2.11).
5 Enter Diagnostic Mode - Input H/L, T/A Roll Sensor Detect (Select Roll 4). Insert a sheet of paper
into the Tray 4 Take Away Sensor and press [4], then remove the sheet of paper and press [4].
The Control Panel LCD displays "IS WITH PAPER" when paper is inserted into the Tray 4 Take
Away Sensor and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 126 and P/J 406 (WIR 8.4.5.1). If OK, Replace the Tray 5
Take Away Sensor (PL 8.4.2.4).
6 Enter Diagnostic Mode - Output Test, TTM Feed Motor Operations to start the HCF Motor. Open
the HCF Left Cover. The Take Away Rolls rotate when the HCF Motor runs.
Y N
|
Troubleshoot the drive transmission from the HCF Motor to Tray 3, Tray 4, Tray 5, Take
Away Gears. Replace if necessary (PL 8.4.2.2).
7 Replace the HCF PWB (REP 8.4.3.5). The error message reappears.
Y N
|
Problem solved.
8 Replace the Printer Engine Controller PWB (REP 4.10.6)
Options
.
3/99
8-254 DocuPrint N24, N32 and N40 Service Manual