Rap 8.5.7.9 Error Code "Clear Area H - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.9 Error Code "Clear Area H"

1 Open and close the Eject Chute. The error code reappears.
Y N
|
Problem solved.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3). Inspect the molded tab on the
Eject Chute that actuates the Safety Switch. Raise and lower the Eject Chute. The actuator tab is
in good condition (unbroken) and the tab actuates and deactuates the Safety Switch.
Y N
|
Replace the Eject Chute Assembly (REP 8.5.3.62).
3 Actuate the Front Cover Interlock Switch. Enter Diagnostic Mode - Input H/L - Finisher Compil
Sensor/Switch - Cover Safety Sw. Close the Eject Chute just enough so the Compiler Cover
Interlock Switches actuate. Manually actuate and deactuate the Safety Switch. The Control
Panel LCD displays H when the Switch is actuated and L when the Switch is deactuated.
Y N
|
Replace the Safety Switch (REP 8.5.3.78).
4 Replace the Finisher PWB (REP 8.5.3.83). The error code reappears.
Y N
|
Problem solved.
5 Replace the Printer Engine Controller PWB (REP 4.10.6).
Options
3/99
8-546 DocuPrint N24, N32 and N40 Service Manual