Rap 7.2 Paper Jam/Clear Area A Entry - Xerox DocuPrint N24 Service Manual

RAP 7.2 Paper Jam/Clear Area A Entry

Use the following procedure to determine the RAP required to troubleshoot the appropriate paper jam.
NOTE: Verify that all paper trays have paper and all trays are in the feed position.
1 Switch the printer power off, then on. Generate a Configuration Sheet (5.5.2.2.1) for Version 1.7X
and below or (5.6.2.2.1) for Version 1.8X from all Trays and outputted to the face down bin and
face up bin. The message "Paper Jam/Clear Area A" is displayed on the Control Panel and
paper is jammed at or before the Registration Sensor.
Y N
|
Go to step 3.
2 Go to RAP 7.8.
3 The paper is jammed between the Registration Sensor and the Fuser Exit Sensor.
Y N
|
Go to step 5.
4 Go to RAP 7.9.
5 The paper is jammed when the face up bin is selected.
Y N
|
Go to step 7.
6 Go to RAP 7.10.
7 The Duplex Option is installed and the jam occurs when the Duplex option is used.
Y N
|
Go to step 9.
8 Go to RAP 8.1.7.1.
9 The Envelope Feeder is installed and the jam occurs when the Envelope Feeder Option is used.
Y N
|
The jam occurs when the HCF Option is used. Go to RAP 8.4.7.4.
10 Go to RAP 8.3.7.2.
Repair Analysis Procedures (RAP)
3/99
7-8 DocuPrint N24, N32 and N40 Service Manual