Rep 8.4.3.9 Trays 3, 4, And 5 Feed Clutches - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

REP 8.4.3.9 Trays 3, 4, and 5 Feed Clutches

Parts List on PL 8.4.2.5

Removal and replacement of the three Feed Clutches are very similar. Differences are noted in the text.

1 Switch the printer power off and disconnect the AC power cord.

2 Remove the Rear Cover (REP 8.4.3.1).

3 Open the Paper Tray associated with the Feeder Assembly you are going to remove.

4 Disconnect the Feed Clutch P/J (Figure 8.4.3.9a).

NOTE: For Tray 3 Feed Clutch, you may have to remove the E-ring of the gear immediately to the right of

the Feed Clutch, and slide that gear forward so you can remove the Feed Clutch.

5 Remove the E-ring securing the Feed Clutch to the Feed Shaft and slide the Clutch off of the

Shaft (Figure 8.4.3.9a).

1 Position the Feed Clutch on the Feed Shaft so the notch on the Clutch lines up with the tab on

the frame. Slide the Feed Clutch onto the Feed Shaft and use an E-ring to secure Clutch to the

2 If you removed the E-Ring of the gear immediately to the right of the Feed Clutch, reinstall the

gear and secure it with an E-ring

3 Reconnect the Feed Clutch P/J.

4 Close the Paper Tray.

5 Reinstall the HCF Rear Cover.

DocuPrint N24, N32 and N40 Service Manual

Figure 8.4.3.9a. Trays 3, 4, and 5 Feed Clutches

Table of Contents