Rap 8.5.7.10 Error Code "Close Cover H - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

RAP 8.5.7.10 Error Code "Close Cover H"

1 Open and close the Eject Chute. The error code reappears.

Problem solved.

2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3). Inspect the molded tab on the

Eject Chute that actuates the Compiler Cover Interlock Switch actuator. Raise and lower the

Eject Chute. The actuator tab is in good condition (unbroken), and the tab actuates and

deactuates the Interlock Switch actuator, and the actuator actuates and deactuates the Switches.

Replace the Eject Chute Assembly (REP 8.5.3.62).

3 Actuate the Front Cover Interlock Switch. Enter Diagnostic Mode - Input H/L - Finisher Compil

Sensor/Switch - Cover Interlock Sw. Manually actuate and deactuate each of the two Compiler

Cover Interlock Switches. The Control Panel LCD displays H when each Switch is deactuated

and L when each Switch is actuated.

Replace the faulty Compiler Cover Interlock Switch (REP 8.5.3.78).

4 Replace the Finisher PWB (REP 8.5.3.83). The error code reappears.

Problem solved.

5 Replace the Printer Engine Controller PWB (REP 4.10.6).

DocuPrint N24, N32 and N40 Service Manual

Table of Contents