Rap 8.5.7.11 Error Code "Slide In Finisher - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.11 Error Code "Slide In Finisher"

1 Push the Finisher against the printer. The error code reappears.
Y N
|
Problem solved.
2 Pull the Finisher a few inches away from the printer, but do not disconnect the Finisher interface
cables. Enter Diagnostic Mode - Input H/L - Finisher Interlock Sw. Push in and release the
Finisher Interlock Sensor actuator. The Control Panel LCD displays L when the interlock is
actuated H when the interlock is deactuated.
Y N
|
Replace the Finisher Interlock Sensor and Actuator (REP 8.5.3.15).
3 Replace the Finisher PWB (REP 8.5.3.83). The error code reappears.
Y N
|
Problem solved.
4 Replace the Printer Engine Controller PWB (REP 4.10.6).
Options
3/99
8-548 DocuPrint N24, N32 and N40 Service Manual