Maintenance Reset Procedure; Maintenance Kit Counter Reset Procedure - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

5.11 Maintenance Reset Procedure

NOTE: The following procedure must be performed to reset the Maintenance Counter after a Kit is

NOTE: The Maintenance Kit counter should only be reset when a complete kit has been installed.

Maintenance Kit Counter Reset Procedure

A Power off the printer.

B Hold down keys [2] <Item Up> and [6] <Item Down> at the same time and power on the printer.

C Continue holding down keys [2] and [6] until the message "*IOT?*" appears.

D Within 5 seconds after the "*IOT?*" message appears, hold down the [0] <On Line> and [5]

<Menu Down> keys at the same time until the message "Reset Complete Please Reboot"

appears. This message confirms the counter has been reset.

E Reboot Printer by powering off then on.

NOTE: The Maintenance Kit is a customer purchased / Customer installed CRU. The interval for

replacement is 300K prints.

Kit contents - (1) Fuser Assembly, (1) BTR Assembly, (15) Feed Rollers, (1) Cleaning cloth, & Install

Instructions.

Maintenance Kit Part #

110V - 109R000486

220V - 109R000487

DocuPrint N24, N32, N40, N3225, and N4025

General Procedures and Information

Table of Contents