REP 8.5.3.67 Paddle Drive Belt
Parts List on PL 8.5.2.13
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
3 Remove the Upper Rear Cover (REP 8.5.3.5).
4 Remove the Eject Cover (REP 8.5.3.7).
5 Remove the Eject Chute Assembly (REP 8.5.3.62).
6 Remove the Eject Pinch Roll Shaft Assembly (REP 8.5.3.63).
7 Remove the two screws securing the Front Pinch Roll Cover to the Eject Pinch Roll Shaft, and
slide the Cover off of the Shaft (Figure 8.5.3.67a).
8 Remove the E ring securing the Paddle Cover Assembly to the Eject Pinch Roll Shaft, and slide
the Cover Assembly off of the Shaft (Figure 8.5.3.67a).
9 Remove the screw securing the Sensor Bracket to the Paddle Cover Assembly, and remove the
Bracket (Figure 8.5.3.67a).
10 Pry the Paddle out of the Paddle Cover Assembly (Figure 8.5.3.67a).
11 Remove the Paddle Drive Belt (Figure 8.5.3.67a).
Options
Figure 8.5.3.67a. Paddle Drive Belt.
3/99
8-422
DocuPrint N24, N32 and N40 Service Manual