Rap 8.4.7.5 Error Code "Clear Area C Reset Tray 5 - Xerox DocuPrint N24 Service Manual

RAP 8.4.7.5 Error Code "Clear Area C Reset Tray 5"

1 Inspect the paper that is loaded in the paper tray. The paper loaded in the tray is smooth (not
wrinkled) and not damaged.
Y N
|
Replace the paper with new paper.
2 Inspect the paper path for paper scraps or foreign objects that could cause a paper jam. The
paper path is clear.
Y N
|
Clear the paper path.
3 Enter Diagnostic Mode - Output Test, Tray 5 Lift Motor to test the Tray 5 Lift Up Motor function.
The Motor switches on when the Output Test starts.
Y N
|
Replace Tray 5 Lift Up Motor (REP 8.4.3.6)
4 Enter Diagnostic Mode - Output Test, Feed Clutch Operation (Select Tray 5) to energize the
clutch, and TTM Feed Motor Operation to check the Tray 5 Feed Clutch function. The Tray 5
Feed Clutch energizes and the Feed Rolls rotated when the Output Test starts.
Y N
|
Check the wiring between P/J 406 and P/J 215 (WIR 8.4.5.1). If OK, replace the Tray 5
Feed Clutch.
5 After performing step 4, carefully open Tray 5. A sheet of paper was fed out of Tray 5.
Y N
|
Replace Tray 5 Feeder Assembly.
6 Enter Diagnostic Mode - Input H/L, T/A Roll Sensor Detect (Select Roll 4). Insert a sheet of paper
into the Tray 4 Take Away Sensor and press [4], then remove the sheet of paper and press [4].
The Control Panel LCD displays "IS WITH PAPER" when paper is inserted into the Tray 4 Take
Away Sensor and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 406 and P/J 126 (WIR 8.4.5.1). If OK, replace the Tray 4
Take Away Sensor (PL 8.4.2.11).
7 Replace the HCF PWB (REP 8.4.3.5). The error message reappears.
Y N
|
Problem solved.
8 Replace the Printer Engine Controller PWB.
DocuPrint N24, N32, N40, N3225, and N4025
2/2000
8-253 Options