Replacement
1 Position the Tamper Motor Drive Belt so the ribs are on the inside of the Belt loop.
2 Slip the Belt over the Tension Pulley.
3 Insert the Belt between the Top and Bottom of the Belt Holder, and tighten the screw on the Belt
Holder.
4 Reinstall the Tamper Motor.
5 Tighten the Belt Tension Screw.
6 Reinstall the Eject Roll Chute and use the four screws to secure it to the frame.
7 Reinstall the Tie Plate and use the four screws to secure it to the frame.
8 Reinstall the Top Bin Assembly.
9 Reinstall the Upper Left Cover.
10 Reinstall the Transport Assembly.
11 Reinstall the Upper Rear Cover.
12 Reinstall the Stapler Door Inner Cover Assembly.
13 Reconnect the Finisher to the printer.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.5.3.53b. Motor Drive Belt.
3/99
8-397
Options