Rap 8.1.7.3 Error Code "Paper Jam/Clear Area A - Xerox DocuPrint N24 Service Manual

RAP 8.1.7.3 Error Code "Paper Jam/Clear Area A"

1 Inspect the paper that is loaded in the paper cassette. The paper loaded in the cassette is
smooth (not wrinkled) and is not damaged.
Y N
|
Replace the paper with new paper.
2 Observe the location of the last sheet of paper out of the Duplex Module. The paper exits the
Duplex Module.
Y N
|
Go to step 5.
3 Enter Diagnostic Mode - Input H/L, Duplex Sensor Detect (EXIT). Insert a sheet of paper into the
Duplex Module Exit Sensor and press [4], then remove the sheet of paper and press [4]. The
Control Panel LCD displays "IS WITH PAPER" when you insert the paper into the Duplex Module
Exit Sensor, and the LCD displays "IS WITHOUT PAPER" when you remove the paper.
Y N
|
Check the wiring between P/J 124 and P/J 404 (WIR 8.1.5.1). If OK, replace the Duplex
Exit Sensor (REP 8.1.3.8).
4 Replace the Duplex PWB (REP 8.1.3.5).
5 Open the Inner Chute and observe the location of the jammed sheet of paper. The paper
actuates the Wait Sensor.
Y N
|
Go to step 11.
6 Enter Diagnostic Mode - Input H/L, Duplex Sensor Detect (WAIT). Insert a sheet of paper into the
Duplex Module Wait Sensor and press [4], then remove the sheet of paper and press [4]. The
Control Panel LCD displays "IS WITH PAPER" when you insert the paper into the Duplex Module
Wait Sensor, and the LCD displays "IS WITHOUT PAPER" when you remove the paper.
Y N
|
Check the wiring between P/J 123 and P/J 404 (WIR 8.1.5.1). If OK, replace the Duplex
Wait Sensor (REP 8.1.3.11).
7 Enter Diagnostic Mode - Output Test, Duplex Operation (Motor Slow) to check the Duplex Drive
Motor. The Duplex Drive Motor runs and the gears on the Drive Assembly rotate.
Y N
|
Check the wiring between P/J 223 and P/J 404 (WIR 8.1.5.1). If OK, replace the Duplex
Drive Assembly (REP 8.1.3.7).
8 While running Diagnostic Mode - Output Test, Duplex Operation (Motor Slow) observe the Exit
and Transport Rolls. The Exit Roll and Transport Roll rotates when you run the test.
Y N
|
Replace the Exit Roll Belt (REP 8.1.3.13).
9 Replace the Exit Roll (REP 8.1.3.10). The problem still exists.
Y N
|
Problem is resolved.
10 Replace the Duplex PWB (REP 8.1.3.5).
Options
3/99
8-58 DocuPrint N24, N32 and N40 Service Manual