Xerox DocuPrint N24 Service Manual page 957

9 Set Clamp Home Sensor
Monitors whether or not the Set Clamp is in the home position.
10 Set Clamp Motor
Drives the Set Clamp paddles to clamp a paper set onto the Compiler Bin prior to stapling.
8.5.6.4.4 Eject and Offset
The Eject and Offset transport and offset compiled sets of paper into the Finisher Bins.
1 Eject Clamp and Offset Motor
Raises and lowers the Eject Chute and Pinch Roll, and drives the Offset Actuator.
2 Eject Clamp Sensor
Monitors whether the Eject Roll is in the up or the down position.
3 Offset Home Sensor
Monitors whether or not the Eject Roll is in the home position.
4 Eject Motor
Drives the Eject Shaft Assembly.
8.5.6.4.5 Elevator Unit
Provides the mechanism for raising and lowering the three Bins.
1 Finisher Bin Elevator Motor
Rotates the Drive shaft clockwise to raise the Bins and counter clockwise to lower the Bins.
2 Finisher Bin ID Sensor
Monitors the Finisher for correct Bin positions during initialization.
3 Finisher Upper Limit Switch
Safety switch in case the Elevator Motor raises the Bins too far. This switch cuts DC to the
Elevator Motor.
4 Finisher Lower Limit Switch
Safety switch in case the Elevator Motor lowers the Bins too far. This switch cuts DC to the
Elevator Motor.
5 Finisher Lower Safety Switch
Monitors for any obstacles under the Bottom Bin.
6 Finisher Height Sensor
Monitors the position of the Bins.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-519 Options