Rap 7.4 Jam Area B / Reset Tray 2 (C2-2) - Xerox DocuPrint N24 Service Manual

RAP 7.4 Jam Area B / Reset Tray 2 (C2-2)

1 Inspect the paper that is loaded in the paper tray. The paper loaded in the tray is smooth (not
wrinkled) and undamaged.
Y N
|
Replace the paper with new paper.
2 Inspect the paper path for paper scraps or foreign objects that could cause a paper jam. The
paper path is clear.
Y N
|
Clear the paper path.
3 Enter Diagnostic Mode - 5.4.5 Running a Service Output Test, Lift Up Motor Operation to test the
Tray 2 Lift Up Motor function. The Motor runs when the Output Test starts.
Y N
|
Check wiring between P/J 408 to P/J 241 (6.3.12). If OK, replace Tray 2 Lift Up Motor (REP
4.2.2).
4 Enter Diagnostic Mode - 5.4.5 Running a Service Output Test, Feed Clutch Operation (Select
Tray 2) to check the Tray 2 Feed Clutch function. The Tray 2 Feed Clutch energizes when the
Output Test starts.
Y N
|
Check wiring between P/J 408 to P/J 240 (6.3.12). If OK, replace the Tray 2 Feed Clutch
(REP 4.2.4).
5 Generate a System Controller Test Print (5.5.2.2.2) for Version 1.7X and below or (5.6.2.2.2) for
Version 1.8X to check the Tray 2 Feed function. A sheet of paper was fed out of paper Tray 2 and
into the Take Away Roll area.
Y N
|
Replace Tray 2 Feed Rolls (REP 4.2.5).
6 Enter Diagnostic Mode - 5.4.5 Running a Service Output Test, Main Motor On/Off to start the
Main Motor. Open the Tray 2 Transport Cover. The Take Away Rolls rotate when you run the
Main Motor.
Y N
|
Replace Tray 2 Take Away Rollers (REP 4.2.7)
7 Enter Diagnostic Mode - 5.4.6 Running a Service Sensor (H/L) Input Test, T/A Roll Sensor Detect
(Select Roll 2). Insert a sheet of paper into the Tray 2 Take Away Sensor and press [4], then
remove the sheet of paper and press [4]. The Control Panel LCD displays L when paper is
inserted into the Tray 2 Take Away Sensor and displays H when the paper is removed.
Y N
|
Check wiring between P/J 408 and P/J 143 (6.3.12). If OK, replace the Tray 2 Take Away
Sensor (PL 5.2).
8 Replace the Printer Engine Controller PWB (REP 4.10.6).
Repair Analysis Procedures (RAP)
3/99
7-10 DocuPrint N24, N32 and N40 Service Manual