Rep 1.9 Input Tray / Printer Cover Assembly; Rep 1.10 Input Tray Extension; Rep 1.11 Paper Side Plates - Xerox Telecopier 7017 Technical Reference Manual

REP 1.9 Input Tray / Printer Cover
Assembly
Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Open printer.
4. Remove input tray /
assembly.
a. Loosen the two screws securing the
input tray / printer cover assembly to
the upper printer frame.
b. Lift rear of input tray / printer cover
assembly to clear screws, then slide it
towards the left and rear to clear
printer release lever and the two
cutouts on the upper printer frame.
5. If replacing input tray / printer cover
assembly, remove input tray extension
(REP 1.10).
Replacement
Reinstall in reverse order.
REP 1.9, 1.10, 1.11

REP 1.10 Input Tray Extension

Parts List on PL 1.2
Removal
1. Remove document catch tray assembly
(REP 1.1).
2. Remove input tray extension.
a. Rotate input tray extension to a
vertical position.
b. Press bottom center of input tray
printer cover
extension until pivot pins release
from locating holes.
Replacement
Reinstall in reverse order.
6/88
4-6
www.printcopy.info

REP 1.11 Paper Side Plates

Parts List on PL 1.3
Removal
1. Remove document catch tray assembly
(REP 1.1).
2. Open printer.
3. Remove paper side plates.
a. Remove recording paper.
b. Remove paper side plate/plates.
Replacement
1. Reinstall paper side plate in the LH
locating slots of base frame so that the
correct paper size is printed facing the RH
frame.
2. Reinstall paper side plate in the RH
locating slots of base frame so that the
correct paper size is printed facing the LH
frame.
3. Reinstall recording paper.
4. Close printer.
5. Reinstall document catch tray assembly
(REP 1.1).
Telecopier 7017 / 7017SF