Rap 8.5.7.12 Error Code "Finisher Fail Power Off/On - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.12 Error Code "Finisher Fail Power Off/On"

NOTE: This procedure checks various components on each of the Bins. It is only necessary to run the
tests for the bin that is suspected of causing the problem.
1 Remove the Eject Cover (REP 8.5.3.7). Inspect the Stack Height Sensor actuator. The actuator
is unbroken and moves freely between the Sensor arms and has a spring-action return.
Y N
|
Replace the Stack Height Sensor Actuator (REP 8.5.3.68).
2 Enter Diagnostic Mode - Input H/L - Finisher Stacker Sensor/Switch - Height Sensor. Manually
actuate and deactuate the Stack Height Sensor. The Control Panel LCD displays L when the
sensor is deactuated and H when the Sensor is actuated.
Y N
|
Replace the Stack Height Sensor (REP 8.5.3.68).
3 Enter Diagnostic Mode -
- Output - Finisher Operations - Stacker T 1 CW, to check the Top Bin Motor.
- Output - Finisher Operations - Stacker T 2 CW, to check the Middle Bin Motor.
- Output - Finisher Operations - Stacker T 3 CW, to check the Bottom Bin Motor.
Enter Diagnostic Mode -
- Output - Finisher Operations - Stacker T 1 CCW, to check the Top Bin Motor.
- Output - Finisher Operations - Stacker T 2 CCW, to check the Middle Bin Motor.
- Output - Finisher Operations - Stacker T 3 CCW, to check the Bottom Bin Motor.
The Bin Motor rotates in both directions.
Y N
|
Replace the appropriate Bin Motor (REP 8.5.3.24) (REP 8.5.3.34) (REP 8.5.3.45).
4 Enter Diagnostic Mode -
- Output - Finisher Operations - Stacker T 1 CW, to check the Top Bin Belts.
- Output - Finisher Operations - Stacker T 2 CW, to check the Middle Bin Belts.
- Output - Finisher Operations - Stacker T 3 CW, to check the Bottom Bin Belts.
Enter Diagnostic Mode -
- Output - Finisher Operations - Stacker T 1 CCW, to check the Top Bin Belts.
- Output - Finisher Operations - Stacker T 2 CCW, to check the Middle Bin Belts.
- Output - Finisher Operations - Stacker T 3 CCW, to check the Bottom Bin Belts.
The Bin Drive Belts raises and lowers the Bin.
Y N
|
Replace the appropriate Bin Drive Belts (REP 8.5.3.26) (REP 8.5.3.36) (REP 8.5.3.46).
5 Enter Diagnostic Mode -
- Input H/L - Finisher Stacker Sensor/Switch - Bin 1 Up Limit Sw, for Top Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 2 Up Limit Sw, for Middle Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 3 Up Limit Sw, for Bottom Bin.
Manually insert and remove paper from between sensor arms of the Bin Upper Limit Sensor. The
Control Panel LCD displays L or H as the paper is inserted and removed.
Y N
|
Replace the Bin Upper Limit Sensor (REP 8.5.3.41) (REP 8.5.3.31) (REP 8.5.3.21).
DocuPrint N24, N32 and N40 Service Manual
3/99
8-549 Options