Rep 4.2.3 Tray 1 Feed Clutch - Xerox DocuPrint N24 Service Manual

REP 4.2.3 Tray 1 Feed Clutch

Parts List on PL 3.2
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Upper Rear Cover Assembly (REP 4.1.3).
3 Remove the Duplex Unit, if installed.
4 Open the Upper Left Cover.
5 Remove the Left Hand Inner Cover (PL 1.3) (Figure 4.2.3a).
6 Remove the E-ring and the 22/20T Gear (Figure 4.2.3a).
7 Disconnect the P/J attached to the Tray 1 Feed Clutch wire harness (Figure 4.2.3a).
8 Remove the E-ring that is securing the Feed Clutch to the shaft (Figure 4.2.3a).
9 Slide the Feed Clutch off the shaft (Figure 4.2.3a).
Replacement
1 Slide the Clutch onto the shaft making sure the stop key on the frame is in the slot in the Clutch.
2 Use the E ring to secure the Clutch to the shaft.
3 Route the wire harness under the Support Spring and reconnect it to the inline connector.
4 Reinstall the 22/20T Gear and secure with the E-ring.
5 Reinstall the Left Hand Inner Cover.
6 Close the Upper Left Hand Cover and reinstall the Duplex Unit, if removed.
7 Reinstall the Upper Rear Cover Assembly.
8 Verify proper operation.
DocuPrint N24, N32 and N40 Service Manual
Figure 4.2.3a. Tray 1 Feed Clutch.
3/99
4-17 Repair Procedures