Rep 4.8.2 Exit Drive Assembly - Xerox DocuPrint N24 Service Manual

REP 4.8.2 Exit Drive Assembly

Parts List on PL 9.4
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Offset / Exit Assembly (REP 4.8.1).
3 Remove the three screws securing the Exit Drive Assembly to the Offset / Exit Assembly.
4 Pull the Exit Drive Assembly straight out and away from the Offset / Exit Assembly.
Replacement
1 Align the Exit Drive Assembly with the Offset / Exit Assembly so the gear and shaft fit through the
corresponding opening in the Exit Drive Assembly.
2 Press the Exit Drive Assembly onto the Offset / Exit Assembly, slightly repositioning the
Assembly so the positioning pins on the Offset / Exit Assembly fits through the hole in the Exit
Drive Assembly.
3 Check to make sure you do not trap any wire harnesses between the Exit Drive Assembly and
the Offset / Exit Assembly.
4 Use three screws to secure the Exit Drive Assembly to the Offset / Exit Assembly.
5 Reinstall the Offset / Exit Assembly.
6 Verify proper operation.
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.8.2a. Exit Drive Assembly.
2/2000
4-73 Repair Procedures