REP 8.5.3.82 Eject Clamp Offset Motor
Parts List on PL 8.5.2.19
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Roll the Finisher away from the printer until it stops.
3 Remove the Upper Rear Cover (REP 8.5.3.5).
4 Remove the Eject Clamp Sensor (REP 8.5.3.57).
5 Remove the Offset Home Sensor (REP 8.5.3.58).
6 Remove the Eject Bracket Assembly (REP 8.5.3.59).
7 Remove the E ring securing the One Way Gear to the Offset Cam Assembly, and remove the
Gear (Figure 8.5.3.82a).
8 Remove the E ring securing the Rear Offset Cam Assembly Bearing, and remove the Bearing
(Figure 8.5.3.82a).
9 Remove the Offset Cam Assembly from the Eject Bracket.
10 Remove the E ring securing the Drive Gear, and remove the Gear (Figure 8.5.3.82a).
11 Remove the two Idler Gears (Figure 8.5.3.82a).
12 Remove the three screws securing the Eject Clamp Offset Motor, and remove the Motor from the
Eject Bracket Assembly (Figure 8.5.3.82a).
Options
Figure 8.5.3.82a. Eject Clamp Offset Motor.
3/99
8-444
DocuPrint N24, N32 and N40 Service Manual