Rep 8.5.3.53 Tamper Motor Drive Belt - Xerox DocuPrint N24 Service Manual

REP 8.5.3.53 Tamper Motor Drive Belt

Parts List on PL 8.5.2.11
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Lower the Stacker Elevator so the Bottom Bin is at the lowest possible position.
3 Disconnect the Finisher from the Printer (REP 8.5.3.1).
4 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3)
5 Remove the Upper Rear Cover (REP 8.5.3.5).
6 Remove the Transport Assembly (REP 8.5.3.11).
7 Remove the Upper Left Cover (REP 8.5.3.12).
8 Remove the four screws securing the Tie Plate to the Finisher frame (Figure 8.5.3.53a). Remove
the Tie Plate.
9 Remove the Top Bin Assembly (REP 8.5.3.38).
10 Remove the four screws securing the Eject Roll Chute to the Finisher frame (Figure 8.5.3.53a).
Remove the Chute.
11 Remove the Tamper Motor (REP 8.5.3.49).
12 Loosen, do not remove, the screw on the Belt Holder, and slip the Belt out of the holder (Figure
8.5.3.53b).
13 Loosen the screw that secures the Belt Tension Pulley (Figure 8.5.3.53b).
14 Slip the Belt off of the Tension Pulley, and remove the Belt (Figure 8.5.3.53b).
Options
Figure 8.5.3.53a. Tie Plate and Eject Roll Chute.
3/99
8-396 DocuPrint N24, N32 and N40 Service Manual