Xerox DocuPrint N24 Service Manual page 147

Replacement
1 Reinstall the Retard Assembly on the Take Away Roll Shaft. Install the E-ring (Figure 4.2.7c).
2 Reinstall the Take Away Roll Assembly in the printer. Ensure that the front white bearing is to the
front of the Take Away Sensor (Figure 4.2.7c).
3 Reinstall the front bearing and E-ring (Figure 4.2.7c).
4 Ensure that the slots in the tabs of the white bearings are mated with the tabs on the printer
frame.
5 Reinstall the Gear Stopper and the screw (Figure 4.2.7c).
6 Ensure that the rear white bearing is properly inserted in the Retard Assembly Bracket.
7 Reinstall the E-ring between the center white bearing and the rubber roll (Figure 4.2.7c).
8 Reinstall the E-ring on the shaft next to the Gear Stopper (Figure 4.2.7c).
9 Reinstall the Gear and E-ring on the Take Away Roll Shaft (Figure 4.2.7c).
10 Reinstall the Take Away Roll Clutch Stop Bracket.
11 Reinstall the Retard Assembly Spring (Figure 4.2.7c).
12 Slightly lift the Retard shaft and reinstall the metal Feed In Chute. Install the chute slightly to the
front and slide to the rear to engage the tabs. Install the screw to secure (Figure 4.2.7c).
13 Reinstall the plastic Feed Out Chute. Note that the front mounting on the chute is slotted. The
collar on the front white bearing goes into the slot (Figure 4.2.7c).
14 Reinstall the Lower Left Cover Interlock Sensor.
15 Reinstall the remaining components.
16 Verify proper operation.
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.2.7c. Take Away Roll Replacement.
2/2000
4-33 Repair Procedures